OMM 20CCM MLHM Type Geroler High Speed Small Hydraulic Orbit Motor

Score

Sold: 0 Question And Answer 0

MOQ: 0 PCS

Note: If you have any questions,please contact us

1.Advanced manufacturing devices for the Gerotor gear set, which provide small volume, high efficiency and long life.
2.Shaft seal can bear high pressure of motor of which can be used in parallel or in series.
3.Advanced construction design, high power and low weight.

OMM 20ccm

More Products Share Factory

Consult Immediately Batch Inquiry

XINGTAI FEIYUE HYDRAULIC PARTS FACTORY

Since:

1985

Model		OMM-8	OMM-12.5	OMM-20	OMM-32	OMM-40	OMM-50
Geometric displacement（cm²/rev.）		8.2	12.9	19.9	31.6	39.8	50.3
Max.speed（rpm）	cont.	1950	1550	1000	630	500	400
Max.speed（rpm）	int.	2450	1940	1250	800	630	500
Max.torque *(Nm)**	cont.	11	16	25	40	45	46
Max.torque *(Nm)**	int.	15	23	35	57	70	88
Max.output （kw）	cont.	1.8	2.4	2.4	2.4	2.2	1.8
Max.output （kw）	int.	2.6	3.2	3.2	3.2	3.2	3.2
Max.pressure drop (MPa)	cont.	10	10	10	10	9	7
Max.pressure drop (MPa)	int.	14	14	14	14	14	14
Max.flow (L/min)	cont.	16	20	20	20	20	20
Max.flow (L/min)	int.	20	25	25	25	25	25
Max.inlet pressure (MPa)	cont.	17.5
Max.inlet pressure (MPa)	int.	22.5
Net weight (kg)		1.9	2	2.1	2.2	2.3	2.4
Rated speed and rated torque: output value of speed and torque under rated flow and rated pressure; Continuous pressure: Max.value of operating motor continuously; Intermittent pressure: Max. value of operating motor in 6 seconds per minute; Peak pressure: Max.value of operating motor in 0.6 second per minute.

1.The maximum working pressure refers to the maximum inlet pressure,while the continuous working pressure refers to the differential working pressure.

2.The motor can not work at the maximum pressure and speed at the same time. 3.Under intermittent working conditions,teh running time shall not exceed 10% per minute.

4.68# anti-wear hydraulic oil with viscosity 37-73 Cst and cleanliness ISO18/13 is recommended.

5.The highest working oil temperature is 80℃。

6.Before the motor works at full load,it should run in under 40% of the maximum working pressure for 1 hour.

7.The maximum back pressure of the motor is allowed to be 10MPa,but it is recommended not to exceed 5 MPa.